Controladora de almacenamiento FUJITSU PSAS CP 2100-8i LP — 8 puertos, SATA 6Gb/s y SAS 12Gb/s

The FUJITSU PSAS CP 2100-8i LP is a low-profile storage controller card with eight ports that support SATA at 6Gb/s and SAS at 12Gb/s. Designed for server and storage enclosures, this controller provides direct-drive connectivity for multi-drive arrays and expansion modules. Its compact form factor fits narrow chassis while enabling connection of a mix of SATA and SAS drives to increase storage capacity and maintain throughput for demanding storage workloads.

Advantages

The controller offers eight high-speed ports with support for both SATA 6Gb/s and SAS 12Gb/s interfaces, allowing flexible deployment with a wide range of hard drives and SSDs. The low-profile design permits installation in dense or space-constrained servers. By providing direct-drive connectivity, the unit helps simplify array expansion and reduces reliance on external bridging adapters. The controller is built to integrate into enterprise and rack systems where consistent link rates and device compatibility are required.

Suitable for

• Adding multi-drive connectivity to rack and tower servers
• Expanding capacity in storage arrays and JBOD enclosures
• Integrating mixed SATA and SAS drives in a single system
• Upgrading legacy servers to support higher drive link speeds

Key specifications

• Number of ports: 8 high-speed ports
• Supported interfaces: SATA 6Gb/s and SAS 12Gb/s
• Form factor: low-profile PCIe card
• Connector type: internal drive connectors for direct-drive attachment
• Compatibility: designed for server and storage chassis with PCIe expansion

How to use

Install the controller into an available low-profile PCIe slot following the server manufacturer’s service manual. Connect drives directly to the controller’s internal ports using appropriate data cables or backplane connectors. Ensure the server is powered down and that anti-static precautions are taken during installation. After hardware installation, verify that the system BIOS/UEFI and operating system detect the controller and attached drives; install any vendor-provided drivers or firmware updates as recommended to enable full performance and compatibility.

Recommendations

Use matching cable types and quality connectors to preserve signal integrity at SATA 6Gb/s and SAS 12Gb/s speeds. Keep firmware up to date and follow server manufacturer guidelines for drive population and cooling to maintain reliable operation. When mixing SATA and SAS drives, consult the system documentation for supported configurations and performance considerations.