EUROLITE cable combinado DT-2 DMX IP T-Con XLR de 3 pines 5 m — cable de conexión DMX/IP

The EUROLITE Kombikabel DT-2 DMX IP T-Con 3-pin XLR 5 m — DMX/IP connection cable is a 5-metre cable designed to connect DMX lighting devices with IP-convertible controllers using a standard 3-pin XLR connector. It provides a direct physical connection for signal transmission in stage, club and event lighting installations where DMX and IP equipment are used together. The cable is intended primarily for indoor use and for temporary or touring setups that require a robust, flexible link between fixtures and control hardware.

Advantages

The cable combines DMX and IP compatibility in a single, straightforward cable solution with a 3-pin XLR termination for wide compatibility with conventional DMX devices. With a 5 m length it offers reach suitable for typical fixture-to-controller distances while remaining manageable during installation and transport. Its construction supports reliable signal transfer, making it appropriate for temporary rigging, club stages and event environments where quick setup and secure connections are required.

Suitable for

Key specifications

How to use

Connect the 3-pin XLR ends to the DMX output of the controller and the DMX input on the fixture or to the appropriate IP-conversion device according to your system layout. Ensure connectors are fully seated to maintain secure contact. Route the cable to avoid sharp bends and pinching; secure with tape or cable ties where necessary to prevent strain on connectors. Perform a signal check after making connections to confirm correct addressing and communication between controller and fixtures.

Recommendations

Use the cable for indoor and temporary applications and avoid prolonged exposure to moisture or harsh outdoor conditions. For longer permanent runs or outdoor use, select cables and connectors designed specifically for outdoor-rated and shielded network applications. Inspect connectors and cable integrity regularly, and replace the cable if shielding or insulation is damaged.