Fuente de alimentación HP 180W para RP2 755702-001, fuente de alimentación de repuesto para sistemas HP compatibles

AC adapter HP 180W for RP2 is a replacement power supply designed for HP RP2-compatible systems that require up to 180 watts of input power. This adapter restores power functionality in servers and workstations that accept the RP2 power connector format and power envelope. The unit is intended as a spare part for repair, maintenance, or equipment refurbishment where original-fit power delivery is needed to ensure stable operation under typical server workloads.

Advantages

This 180W AC adapter delivers a consistent rated output suitable for systems designed around the RP2 power interface. It offers a compact form factor for constrained server bays and service carts, and its electrical specifications are matched to provide stable voltage and current under sustained loads. Using a compatible replacement reduces downtime by allowing quick installation in the field and supports continued operation of legacy or mixed hardware environments.

Suitable for

• Repairing RP2-compatible HP servers and workstations
• Replacing a failed or missing power supply in maintenance tasks
• Keeping as a spare part for on-site support and rapid swap-out
• Refurbishing hardware that requires a 180W adapter form factor

Key specifications

• Output power: up to 180 W
• Compatibility: RP2-style power interface for compatible HP systems
• Intended use: server and workstation power delivery
• Form factor: compact replacement adapter for constrained installs
• Electrical behavior: designed for sustained loads and stable voltage output

How to use

Turn off the host system and disconnect it from mains before replacing the adapter. Remove the existing adapter or cover, align the replacement AC adapter with the system’s RP2 power inlet, and secure it according to the system’s service instructions. Reconnect mains power and power on the system to verify proper operation. If the replacement is used during equipment refurbishment, inspect connectors and cable routing before powering the device to avoid strain or contact issues.

Recommendations

Use the adapter only with systems specified to accept an RP2-style 180W supply. Verify voltage and current requirements from the system documentation before installation. For stable operation, ensure adequate airflow and avoid obstructing ventilation around the adapter during use. If unusual noise, heating, or instability occurs after installation, power down the system and consult service documentation or technical support.