G.Skill Ripjaws | 32 GB | DDR5 | 4800 MHz | PC/servidor | Registered No | ECC No

The G.Skill Ripjaws F5-4800S4039A32GX1-RS is a 32GB DDR5 SO-DIMM memory module for laptops and small form factor PCs. With a 4800 MHz clock speed and CAS latency 40, this 262-pin module offers higher data transfer rates and improved energy efficiency compared with DDR4, making it a suitable memory upgrade for systems that support DDR5.

Advantages

Manufactured using specially screened IC chips and subjected to G.SKILL's selective binning and hand-testing process, the Ripjaws DDR5 SO-DIMM provides consistent performance and reliability. The DDR5 architecture increases the number of banks and bank groups and doubles burst length, while the module's two 32-bit sub-channels enable higher data throughput. An on-board PMIC (power management integrated circuit) delivers finer power control and more stable power delivery at high frequencies.

Suitable for

• Laptop memory upgrades
• Small form factor PCs that accept 262-pin SO-DIMM DDR5 modules
• Multitasking and productivity workloads requiring increased memory capacity
• Use cases where improved energy efficiency and signal integrity are desired

Key specifications

• Brand: G.SKILL
• Model: F5-4800S4039A32GX1-RS
• Capacity: 32 GB
• Memory type: DDR5
• Clock speed: 4800 MHz
• CAS latency: 40
• Form factor: 262-pin SO-DIMM
• Voltage: 1.1 V
• EAN: 4713294232557

How to use

Power off the laptop or SFF PC and disconnect it from mains. Open the memory compartment according to the device manufacturer's instructions. Ground yourself to avoid electrostatic discharge. Remove any existing SO-DIMM if necessary, align the notch of the 262-pin module with the slot, insert at a slight angle and press down until the retention clips click into place. Reassemble the device and power it on. Verify that the system recognizes the new 32 GB DDR5 module in BIOS/UEFI or the operating system before use.

Recommendations

Ensure your laptop or small form factor PC officially supports DDR5 262-pin SO-DIMM modules and the 4800 MHz speed. When mixing modules, use identical specifications for best compatibility. Check BIOS/UEFI settings and update firmware if needed to ensure stable operation.