GETFORT GF-48D1000 Adaptador inyector PoE pasivo 48W, 100-240V AC a 48V DC, 10/100 Mbps, 2x RJ45, compatible con IEEE 802.3af/at

Running Ethernet cable to a camera or access point often means dealing with the hassle of separate power lines. The GETFORT GF-48D1000 solves that by combining data and power into a single network cable, so you can install devices in hard-to-reach spots without extra wiring.

Who is it for

This PoE injector is ideal for installers, IT technicians, and DIY enthusiasts who need to power PoE-enabled devices like IP cameras, wireless access points, or VoIP phones where AC outlets are unavailable. It works with any passive PoE device that accepts 48V DC on pins 4/5 (+) and 7/8 (-).

Main features

• Passive PoE injection: delivers up to 48W (48V DC, 1A) over standard Cat5e/6 cable.
• Dual RJ45 ports: one for data input from your switch/router, one for PoE output to the powered device.
• Wide input range: accepts 100-240V AC, 50/60Hz, so it works worldwide with the appropriate power cord.
• Fast Ethernet speed: supports 10/100 Mbps data rates, perfect for IP cameras and access points.
• Built-in protection: short circuit, over voltage, and over current protection keep your equipment safe.
• Compact ABS housing: durable and easy to mount near your network gear.

Specifications

• Input: 100-240V AC, 50/60Hz
• Output: 48V DC, 1A, 48W max
• PoE type: Passive (pins 4/5 +, 7/8 -; data on 1/2, 3/6)
• Data rate: 10/100 Mbps
• Ports: 2x RJ45 (Data In, PoE Out)
• LED indicator: Power
• Protection: SCP, OVP, OCP
• Operating temperature: 0°C to 40°C
• Storage temperature: -20°C to 85°C
• Operating humidity: 5% to 90% non-condensing
• Power connector: IEC C6 (cloverleaf)
• Housing: ABS plastic

Tips

Before connecting, verify that your device supports passive PoE with the same pinout and voltage. This injector is not compliant with active PoE standards like 802.3af/at, so using it with those devices may cause damage. Always use quality Cat5e or better cable for reliable power and data transmission.