Memoria RAM PNY DDR5 16GB 4800MHz DIMM MD16GSD54800-SB

The PNY 16GB DDR5 4800MHz DIMM memory module delivers a single 16GB stick of DDR5 system memory built for mainstream and performance desktop PCs. Using DDR5 technology and a 4800MHz data rate, this module increases memory bandwidth and improves power efficiency compared with previous-generation DIMMs. The module is a standard unbuffered UDIMM form factor intended for desktop motherboards that support DDR5, helping to improve system responsiveness for gaming, content creation, and everyday multitasking.

Advantages

This 16GB DDR5 4800MHz module provides higher data transfer rates and better power management than DDR4 modules of earlier generations. The increased bandwidth supports smoother multitasking, faster application load times, and more consistent frame rates in games. The DIMM's unbuffered design and standard form factor ensure broad compatibility with compatible motherboards, and the lower operating voltage characteristic of DDR5 contributes to improved energy efficiency under load.

Suitable for

• Upgrading a desktop PC to increase available system memory for gaming
• Workstations used for photo and video editing where additional RAM reduces swapping
• General-purpose and multitasking systems that run multiple applications concurrently
• Users building or expanding a DDR5-compatible system on a supported motherboard

Key specifications

• Memory type: DDR5 SDRAM
• Capacity: 16 GB (single module)
• Speed: 4800 MHz data rate
• Form factor: 288-pin DIMM (desktop UDIMM)
• Operating voltage: lower than typical DDR4 nominal voltage (DDR5 standard)
• Unbuffered design for standard consumer desktop platforms

How to use

Install the module into an empty DDR5-compatible DIMM slot on a powered-off motherboard following the motherboard manufacturer’s instructions. Align the module’s notch with the slot key, insert at an angle, and press down firmly until the retention clips engage. For dual-channel or multi-channel configurations, populate the recommended slots as specified by the motherboard manual. After installation, power on the system and verify that the BIOS/UEFI recognizes the new memory capacity and speed. If necessary, enable or configure memory profiles in BIOS/UEFI according to your motherboard’s guidance.

Recommendations

Use this PNY DDR5 16GB 4800MHz DIMM in systems explicitly supporting DDR5 memory. When pairing modules, use identical specifications (capacity and speed) for optimal stability and channel performance. Consult the motherboard memory QVL and update BIOS/UEFI to the latest version to ensure compatibility and to take full advantage of supported memory frequencies.