Módulo transceptor de cobre BlueOptics PAN-SFP-PLUS-10GBASE-T 10000 Mbit/s SFP+

The BlueOptics PAN-SFP-PLUS-10GBASE-T is a copper SFP+ transceiver module engineered for high-speed wired connectivity. Supporting the SFP+ interface, this module delivers data transfer rates up to 10,000 Mbit/s over copper cabling and is supplied as a single unit. Its compact form factor fits SFP+ slots in switches, routers and servers to provide 10GBase-T connectivity where fiber is not required.

Advantages

This copper transceiver offers straightforward deployment in existing copper infrastructures, enabling 10 Gbit/s links without fiber conversion. The SFP+ form factor conserves port density while providing high throughput. The module is compatible with standard SFP+ cages and is suitable for direct connection to copper cabling, simplifying installation and reducing the need for additional media converters.

Suitable for

• Upgrading switch or server ports to 10 Gbit/s over copper
• Data center rack connections where short-range copper is preferred
• Aggregation links and high-speed uplinks in enterprise networks
• Environments where SFP+ modularity is required instead of fixed RJ45 ports

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Transmission medium: copper (10GBase-T)
• Form factor: SFP+ transceiver module
• Pack size: single unit

How to use

Install the module into a free SFP+ slot on a compatible switch, router or server until it latches. Connect standard Category 6A (or appropriate) copper cabling to the RJ45 connector on the module and verify link status through the device management interface. Configure network settings (speed, duplex, VLANs) on the host equipment as required. Follow equipment vendor guidelines for hot-plugging and firmware compatibility.

Recommendations

Use high-quality shielded Category 6A or Cat6e cabling for reliable 10GBase-T performance and limit copper run lengths according to the cabling standard. Confirm SFP+ port compatibility with the host device and check firmware requirements before deployment to ensure stable operation.