Módulo transceptor de fibra óptica BlueOptics 808-38208-BO SFP 120000 m

The BlueOptics 808-38208-BO SFP 120000 m is a fiber optic transceiver module designed for single-mode, long-distance data transmission. It implements the SFP interface and uses an LC duplex connector to send and receive optical signals over single-mode fiber. The module is housed in an aluminium-coloured body and is lightweight for easy installation in compatible network equipment. With a maximum transfer distance of 120,000 m, this transceiver is intended for point-to-point links where extended reach is required.

Advantages

This BlueOptics transceiver provides a standardized SFP form factor for hot-pluggable installation in switches, routers and other network devices that accept SFP modules. The aluminium-coloured housing offers mechanical protection while keeping the unit lightweight. Built to MSA-compatible dimensions and interface definitions, the module supports reliable optical connections over long single-mode fiber runs and is suitable for applications that require a long reach and stable signal transmission.

Suitable for

• Long-distance single-mode fiber links between network sites
• 1 Gbps optical Ethernet and similar high-speed optical applications
• Hot-pluggable upgrades or replacements in SFP-compatible switches and routers
• Point-to-point backbone connections and campus links

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Connector: LC duplex (optical)
• Supported medium: Single-mode fiber
• Maximum transmission distance: 120,000 m
• Weight: 0.02 kg
• Housing colour/material: aluminium-coloured body

How to use

Install the BlueOptics 808-38208-BO by inserting the SFP module into an SFP slot of a compatible network device while the device is powered on or following the vendor's hot-swap guidance. Connect single-mode LC duplex fiber patch cords to the module's LC ports, ensuring correct transmit/receive alignment. Configure the host device to recognize the installed SFP interface and verify link status and speed according to the device management interface. Perform standard optical power and link tests to confirm correct operation over the intended fiber route.

Recommendations

Use single-mode fiber patch cords and keep connectors clean to ensure optimal performance. Verify that the target network hardware supports the SFP transceiver and any optional diagnostic features before deployment. For long runs, follow best practices for fiber routing, splicing, and attenuation budgeting to achieve stable links.