Módulo transceptor de fibra óptica BlueOptics F5-UPG-SFP+-R 10000 Mbit/s SFP+ 850 nm

The BlueOptics F5-UPG-SFP+-R is a fiber optic transceiver module engineered for 10 Gbps links using the SFP+ form factor. Operating at an 850 nm wavelength, this module supports multimode fiber connections and is intended to integrate with compatible SFP+ ports on switches, routers and network interface cards. The compact SFP+ design provides hot-pluggable installation and enables high-density deployments in data centers and enterprise networks without occupying large chassis space.

Advantages

The module delivers a stable 10000 Mbit/s throughput and is built to meet the electrical and optical interfaces expected from SFP+ transceivers. Its 850 nm wavelength is suitable for short-range multimode fiber links, reducing latency and maintaining signal integrity across typical campus and rack-to-rack distances. The small form factor and standard SFP+ interface simplify upgrades and replacements in existing network infrastructures.

Suitable for

• 10 Gigabit Ethernet short-reach multimode fiber connections
• Server and switch uplinks in data center racks
• High-density networking environments requiring hot-pluggable modules
• Network equipment upgrades where SFP+ compatibility is required

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbps)
• Operating wavelength: 850 nm
• Form factor: SFP+ hot-pluggable transceiver
• Optimized for short-range multimode fiber links

How to use

Install the BlueOptics F5-UPG-SFP+-R by inserting the module into a compatible SFP+ port until it clicks into place. Connect a suitable multimode fiber cable with matching LC connectors and ensure both ends are properly secured. Configure link settings on the connected network device if required; most devices will negotiate link parameters automatically. Observe standard handling precautions for optical transceivers such as avoiding contamination of connectors and protecting the module from electrostatic discharge.

Recommendations

For reliable performance, use high-quality multimode fiber and clean LC connectors before mating. Verify compatibility with the host device's SFP+ port and confirm the supported link distances for 850 nm modules. Store unused modules with dust caps and handle them using ESD-safe procedures.