Módulo transceptor de fibra óptica BlueOptics IB-000218-BO SFP+ LC aluminio

The BlueOptics IB-000218-BO SFP+ LC Aluminium is a fiber optic transceiver module designed for 10 Gigabit-class short-range optical links. The module uses an SFP+ interface with an LC duplex connector and is housed in an aluminium casing. Weighing approximately 20 g, it is intended for installation in compatible network equipment to enable high-speed multimode fiber connections and to improve link reliability and physical durability.

Advantages

The SFP+ form factor supports 10GBASE-SR applications over multimode fiber with simultaneous transmit and receive channels through an LC duplex connector. The aluminium housing provides physical robustness and thermal stability while the low weight simplifies handling and installation. The transceiver adheres to MSA-compatible mechanical and electrical specifications for straightforward compatibility with equipment that accepts SFP+ modules.

Suitable for

• 10 Gigabit Ethernet short-range multimode fiber links
• High-speed connections between switches, routers and storage systems
• Data center uplinks and server-to-switch links
• Optical patch panel installations and direct transceiver-to-transceiver links

Key specifications

• Interface type: SFP+
• Connector: LC duplex
• Wavelength: 850 nm (multimode fiber)
• Supported maximum distance: up to 300 m on appropriate multimode fiber
• Housing material: aluminium
• Weight: 0.02 kg
• Supported protocols: 10G Ethernet / 10GBASE-SR

How to use

Install the BlueOptics SFP+ module into a powered-off or hot-swappable SFP+ slot on compatible network hardware according to the host vendor's instructions. Connect the LC duplex multimode fiber patch cord to the module's LC connector, ensuring correct transmit-to-receive orientation. Verify link status in the host device's management interface and, if available, enable or monitor digital diagnostics features supported by the hardware to observe operational parameters.

Recommendations

Use high-quality multimode fiber patch cords and maintain proper cable polarity for optimal signal integrity. Ensure the host device supports 10GBASE-SR SFP+ modules and, when required, confirm DDM/DOM support in the equipment to access diagnostic information. Follow ESD precautions when handling the module and keep optical connectors clean to preserve link performance.