Módulo transceptor de fibra óptica BlueOptics X-000182-R6-BO SFP+ 10000 m

The BlueOptics X-000182-R6-BO SFP+ 10000 m is a fiber optic transceiver module designed for 10G optical links over single-mode fiber with a maximum reach of up to 10,000 meters. The module uses an SFP+ interface in an aluminium housing and weighs approximately 20 g, offering a compact and robust option for network equipment that supports MSA-compliant small form-factor pluggable modules. It features LC Duplex connectivity suited for point-to-point optical links and supports high-speed Ethernet and similar optical transport protocols.

Advantages

The transceiver provides long-reach single-mode transmission at 10 Gbit/s while remaining lightweight and mechanically rugged thanks to its aluminium casing. It complies with SFP+ form-factor standards ensuring physical compatibility with a wide range of switches, routers and storage interfaces that accept MSA-compliant SFP+ modules. Built for optical links with LC Duplex connectors, the module supports simultaneous transmit and receive channels and is designed for reliable, low-latency data transfer over long distances.

Suitable for

• 10 Gbit/s Ethernet links over single-mode fiber up to 10 km
• Interconnections between switches, routers and storage systems
• High-bandwidth server uplinks and data centre links

Key specifications

• Interface type: SFP+
• Optical fiber type: Single-mode fiber
• Connector: LC Duplex
• Typical wavelength: 1310 nm for transmit and receive
• Maximum transmission distance: up to 10,000 m (10 km)
• Data rate: 10 Gbit/s
• Housing material: aluminium
• Weight: approximately 0.02 kg

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on a switch, router or storage device while the host device is powered off or following the device manufacturer's hot-plug guidance. Connect LC Duplex single-mode fiber patch cords to the module's transmit and receive ports, ensuring correct polarity. Verify link status through the host device management interface and confirm that the port is configured for the intended 10G service. If available, enable Digital Diagnostics Monitoring (DDM/DOM) in the host to read real-time optical parameters.

Recommendations

Use single-mode LC Duplex patch cords and follow proper fiber handling practices to avoid contamination or damage to optical interfaces. Confirm host-device compatibility and firmware support for third-party SFP+ modules before deployment. For monitoring and troubleshooting, enable DDM/DOM if supported by the equipment to observe supply voltage, optical power and temperature values in real time.