Módulo transceptor de red BlueOptics TN-SFP-10G-U-20-BO 10000 Mbit/s SFP+

The BlueOptics TN-SFP-10G-U-20-BO network transceiver module is a compact SFP+ optical interface designed for 10 Gbit/s links. This silver-coloured module supports a maximum data transfer rate of 10000 Mbit/s and provides a hot-pluggable, small-form-factor option for upgrading or expanding compatible network equipment. It is compliant with CE, FCC and RoHS standards and is engineered for straightforward installation in equipment that accepts SFP+ modules.

Advantages

The module offers a standardized SFP+ interface for high-speed fibre connectivity while maintaining a lightweight design at approximately 20 g. Its compatibility with common networking hardware simplifies deployment and replacement. Compliance with CE, FCC and RoHS standards ensures regulatory conformity and reduced environmental impact. The small form factor and hot-pluggable capability reduce downtime during upgrades or maintenance.

Suitable for

Key specifications

How to use

Power down the host port or follow hot-swap procedures recommended by the equipment vendor, then insert the SFP+ transceiver into the SFP+ slot until it latches. Connect the appropriate fibre optic cable to the transceiver connector, observing transmit/receive orientation. After installation, verify link status in the host device management interface and confirm speed negotiation at 10 Gbit/s. Follow vendor-specific firmware or compatibility notes if any link issues occur.

Recommendations

Use compatible single-mode or multimode fibre and matching connectors as specified by your network design. Keep the optical ports capped when not in use to prevent contamination, and handle the module by its housing to avoid electrostatic or mechanical damage. Check vendor compatibility lists for the host device to ensure full support of the SFP+ module.