Módulo transceptor SFP+ BlueOptics 02318170 10000 Mbit/s 1310 nm

The BlueOptics 02318170 SFP+ transceiver module is a fiber optic communication component designed for short- to medium-range high-speed network links. Supporting a nominal transmission wavelength of 1310 nm and a maximum data transfer rate of 10,000 Mbit/s, this SFP+ module provides a standard interface suitable for installation in compatible network equipment. It is intended for use in data centers, enterprise networks, and telecom access points where optical connections are required over single-mode or multimode fiber as specified by system designers.

Advantages

This SFP+ module offers a compact, hot-pluggable form factor that simplifies upgrades and replacements without powering down devices. With a 1310 nm wavelength and support for 10 Gbit/s link speeds, it delivers consistent optical performance and interoperability with equipment that accepts SFP+ modules. The module’s standardized interface and industry-compatible design reduce integration complexity and facilitate maintenance in mixed-vendor environments.

Suitable for

• 10 Gbit/s fiber uplinks between switches and routers
• Server-to-switch connections in data center racks
• Optical links in enterprise LAN and campus networks
• Telecommunications access and aggregation links

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 1310 nm
• Form factor: small form-factor pluggable (hot-pluggable)

How to use

Install the BlueOptics 02318170 into an SFP+ port on compliant networking hardware following the device manufacturer’s guidance. Ensure fiber type and connector type used in the link match the network design and transceiver specifications. Verify link integrity and configure interface settings such as speed and duplex on the host device if required. When extracting or inserting the module, follow static-sensitive handling procedures and perform operations while observing hot-plug precautions described by the equipment vendor.

Recommendations

Confirm compatibility with the host equipment and choose appropriate fiber cabling and connectors for the desired link length. Use proper ESD protection during handling and maintain clean optical connectors to ensure optimal signal quality.