Módulo transceptor SFP BlueOptics 331-5409-BO 155 Mbit/s fibra óptica

The BlueOptics 331-5409-BO is a fiber optic SFP transceiver module designed for serial optical communications with a maximum data transfer rate of 155 Mbit/s. Housed in a silver SFP form factor, it provides a compact interface for integrating fiber links into network equipment. The module meets CE, FCC and RoHS standards and has a specified mean time between failures (MTBF) of 1,000,000 hours, indicating long operational life for stable data transmission.

Advantages

This SFP transceiver offers a standardized SFP interface for simple hot-pluggable installation into compatible network ports and media converters. The module’s compact size and low weight make it suitable for dense installations where space and weight are considerations. Compliance with CE, FCC and RoHS ensures regulatory conformity and reduced environmental impact, while the stated MTBF supports planning for long-term reliability.

Suitable for

• Connecting fiber optic links between switches, routers and media converters
• Legacy or lower-speed optical networks operating at up to 155 Mbit/s
• Environments requiring hot-pluggable SFP modules for rapid field replacement
• Installations where a compact silver SFP form-factor transceiver is preferred

Key specifications

• Interface type: SFP
• Maximum data transfer rate: 155 Mbit/s
• Form factor: SFP (small form-factor pluggable)
• Colour: Silver
• Weight: 0.02 kg
• Operational reliability indicator: MTBF 1,000,000 hours
• Standards compliance: CE, FCC, RoHS

How to use

Insert the module into a compatible SFP slot on a switch, router or media converter until it seats firmly and the retention mechanism engages. Connect the appropriate fiber optic cable to the module’s optical connector following the transmit/receive orientation. Configure the network device as required for a 155 Mbit/s link and verify link status through the host device’s management interface or status LEDs. For removal, disengage the retention latch and pull the module straight out to avoid damage to the host port or fiber connectors.

Recommendations

Use compatible single-mode or multimode fiber and matching connectors as required by your network design. Avoid bending the fiber beyond its minimum bend radius and keep connectors capped when not in use to prevent contamination. Ensure firmware or device settings support 155 Mbit/s operation and hot-swap functionality before deployment.