Módulo transceptor SFP+ BlueOptics 44X1964 10000 Mbit/s 850 nm

The BlueOptics 44X1964 SFP+ transceiver module provides 10 Gbit/s fiber-optic connectivity for short-range links using an 850 nm wavelength. Designed for use in data centers, server rooms and enterprise network equipment, this module fits standard SFP+ ports and supports high-speed links over multimode fibre. The compact pluggable form factor allows hot‑swap installation and easy integration into switches, routers and transceivers that accept SFP+ modules.

Advantages

The module supports a maximum data transfer rate of 10000 Mbit/s and operates at 850 nm, offering predictable performance for short-range multimode connections. Its SFP+ interface ensures compatibility with a wide range of networking equipment while keeping power consumption and heat generation low compared with larger form-factor optics. The standardized design facilitates quick replacement and maintenance without system downtime.

Suitable for

• Short-range 10 Gbit/s links in data centers
• Server-to-switch and switch-to-switch connections within racks
• Enterprise access and aggregation layers over multimode fibre

Key specifications

• Interface: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbps)
• Optical wavelength: 850 nm
• Form factor: hot-pluggable SFP+ transceiver
• Optimized for short-range multimode fibre links

How to use

Insert the BlueOptics 44X1964 module into a compatible SFP+ port on your switch, router or network card until it clicks into place. Connect the multimode fibre patch cord with the appropriate connector type to the module's optical interface. Configure the network device according to vendor instructions to enable the 10 Gbit/s port; check link status and diagnostics via the management interface. To remove, release the latch or pull tab and extract the module while the system is powered according to the equipment manufacturer's hot‑swap guidelines.

Recommendations

Use the module with multimode fibre (OM3/OM4 recommended for 10 Gbit/s) and verified patch cords. Confirm compatibility with the host device manufacturer’s SFP+ supported transceiver list when possible. Avoid exposing the optical ports to dust — use dust caps when the module is not connected and store spare modules in protective packaging.