Módulo transceptor SFP BlueOptics EX-SFP-1GE-SX-ET-BO 1250 Mbit/s plateado

The BlueOptics EX-SFP-1GE-SX-ET-BO 1250 Mbit/s Silver is a compact SFP fiber optic transceiver module designed for 1000Base-SX multimode links. It supports a maximum data transfer rate of 1250 Mbit/s and uses LC Duplex connections according to MSA standards. The module transmits and receives optical signals at 850 nm and is painted silver with a lightweight construction of approximately 20 g. It is CE, RoHS and FCC compliant and intended for reliable integration into common network hardware that accepts SFP modules.

Advantages

The EX-SFP-1GE-SX-ET-BO offers broad compatibility with hardware platforms that support standard 1000Base-SX SFP modules, enabling straightforward replacement or upgrade without vendor lock-in. Built to MSA dimensions and manufactured using selected components, the module provides stable optical transmission over multimode fiber and includes support for Digital Diagnostics Monitoring (DDM/DOM) when the host system allows. Its small form factor, low weight and standardized LC Duplex interface simplify installation and cabling in dense networking environments.

Suitable for

Key specifications

How to use

Insert the EX-SFP-1GE-SX-ET-BO module into a compatible SFP slot on the switch, router or other network device while the device is powered down or following the vendor’s hot-swap instructions. Connect an LC Duplex multimode fiber patch cable with matching connectors to the module’s LC ports, observing correct Tx/Rx orientation. Ensure the host device supports 1000Base-SX operation and that any required module support or compatibility settings are enabled. When supported by the host, use the DDM/DOM interface to monitor real-time parameters such as optical power, voltage and temperature for diagnostics and maintenance.

Recommendations

For reliable performance, use high-quality multimode fiber patch cables and keep fiber connectors clean. Verify host compatibility with 1000Base-SX SFP modules and enable DDM/DOM in the host system if remote diagnostics are required. Avoid excessive bending of fiber cables and follow manufacturer guidelines for insertion/removal to prevent damage to the module or port.