Módulo transceptor SFP BlueOptics ode 10-1750-01-BO 155 Mbit/s 1310 nm

The BlueOptics ode 10-1750-01-BO is a fiber optic SFP transceiver module designed for point-to-point and network equipment connections requiring a 155 Mbit/s data rate. Operating at a wavelength of 1310 nm, this compact module comes in a metal housing with a silver finish and weighs approximately 20 g. It is built to industry standards and meets CE, FCC, and RoHS compliance for regulated environments.

Advantages

This SFP transceiver offers a stable 155 Mbit/s link at 1310 nm in a standardized SFP form factor, allowing hot-pluggable installation in compatible switches and routers. The metal housing provides mechanical durability and EMI shielding while the low weight and compact dimensions simplify handling and deployment. With an MTBF of 1,000,000 hours, the module is intended for long-term use in networks where predictable reliability is required.

Suitable for

• Fiber optic connections between switches, routers, and media converters
• Access networks and legacy SDH/SONET or older telecom equipment requiring 155 Mbit/s
• Environments needing CE, FCC and RoHS compliant components

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Data rate: up to 155 Mbit/s
• Transmission wavelength: 1310 nm
• Housing material: metal
• Colour: silver
• Weight: 0.02 kg (approx.)
• Reliability: MTBF 1,000,000 hours
• Standards compliance: CE, FCC, RoHS

How to use

Ensure the host device supports SFP modules and that the required link settings (data rate and wavelength) match the connected equipment. With the host device powered appropriately, insert the BlueOptics SFP into the SFP slot until it seats securely; the module is hot-pluggable but follow the host vendor’s guidance on insertion and removal. Connect the appropriate single-mode fiber cable to the transceiver to establish the optical link. Verify link status and diagnostics through the network device’s management interface.

Recommendations

Handle the optical connector with care to prevent contamination; keep dust caps on when the module is not connected. Install modules in environments within the host equipment’s specified temperature and humidity ranges and use compatible fiber types and connectors to maintain signal integrity.