Módulo transceptor SFP BlueOptics RDH90120/41422-BO 1250 Mbit/s 1550 nm

The BlueOptics RDH90120/41422-BO SFP transceiver module is a compact fiber optic interface designed for 1250 Mbit/s data links over single-mode fiber at a wavelength of 1550 nm. Housed in a silver enclosure and powered from a 3.3 V supply, the module offers a lightweight, hot-pluggable solution for point-to-point and network edge connections where a small form-factor pluggable (SFP) port is required. The module is intended for use in switches, routers and media converters that accept SFP transceivers and supports standard serial data transmission over optical fiber.

Advantages

The BlueOptics SFP module provides a standardized SFP interface that simplifies installation and replacement in compatible networking equipment. With a 1250 Mbit/s maximum data rate and 1550 nm optical wavelength, it is suitable for longer-reach single-mode fiber links. Its low weight and compact metal housing contribute to efficient rack and chassis deployments while the 3.3 V operation ensures compatibility with common SFP ports.

Suitable for

Key specifications

How to use

Ensure the host device supports SFP transceivers with 1550 nm single-mode optics and a 3.3 V supply. With the device powered down or following the vendor's hot-swap instructions, insert the transceiver into an available SFP slot until it latches. Connect single-mode fiber using the appropriate connector type for the transceiver and verify link status via the host device management interface. Configure interface settings on the switch, router or media converter as required for the network topology and verify throughput at the expected 1250 Mbit/s rate.

Recommendations

Handle the transceiver by its housing and avoid touching the optical connector end-face. Keep dust caps in place when not connected and follow ESD precautions during installation. Use compatible single-mode fiber and verify optical budgets and connector types to ensure reliable link performance.