Módulo transceptor SFP+ BlueOptics SBC-SFPMM-10G-BO 10000 Mbit/s

The BlueOptics SBC-SFPMM-10G-BO is an SFP+ fiber optic transceiver module designed for 10G data links. It supports a maximum data transfer rate of 10000 Mbit/s and is intended for multimode fiber connections using an LC duplex connector and 850 nm wavelength for both transmit and receive. Housed in a metal casing and weighing approximately 20 g, the module is built to MSA specifications and provides long service life with an MTBF of around 1,000,000 hours.

Advantages

This SFP+ transceiver offers compatibility with a wide range of hardware that supports MSA-compliant 10GBASE-SR modules, enabling use in switches, routers, storage systems and other network appliances. The module's metal housing and compact SFP+ form factor provide mechanical robustness and ease of installation. Digital Diagnostics Monitoring (DDM/DOM) is supported to allow real-time information on supply voltage, laser bias current, transmit output power, receive input power and module temperature when the host supports it.

Suitable for

• 10 Gbps Ethernet links over multimode fiber (up to standard SR distances)
• Fibre Channel over Ethernet deployments
• High-speed uplinks between switches and routers
• Data center aggregation and server-to-switch connections
• Optical connections in storage and load-balancing systems

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s
• Optical wavelength: 850 nm (TX and RX)
• Connector: LC duplex
• Fiber type: Multimode fiber (MMF)
• Typical reach: up to SR multimode distances (manufacturer SR class)
• Housing: metal
• Weight: approx. 0.02 kg
• MTBF: approx. 1,000,000 hours
• DDM/DOM: supported (requires host support)

How to use

Install the BlueOptics SFP+ transceiver into a compatible SFP+ slot on your switch, router or network appliance following the host vendor's insertion and removal procedures. Connect an LC duplex multimode fiber patch cable, ensuring correct TX/RX orientation. Verify link status via your device management interface and, if required, access digital diagnostics to monitor operating parameters. Ensure the host platform supports the 10GBASE-SR mode and DDM if you intend to use the monitoring features.

Recommendations

Use high-quality multimode fiber patch cords and maintain clean LC connectors to achieve optimal signal quality. Confirm compatibility with your hardware vendor and test the transceiver in your environment if interoperability is critical. For DDM information, make sure the host device supports reading the diagnostics registers.