Módulo transceptor SFP BlueOptics SFP-10G-C-BO fibra óptica SFP+ 30m

The BlueOptics SFP-10G-C-BO Fiber optic SFP+ 30m is a compact SFP+ transceiver module designed for 10G data links over short multimode fiber runs up to 30 meters. Housed in an aluminium casing and weighing approximately 20 grams, this module implements the SFP+ interface for use in compatible switches, routers and storage systems. It supports standard 10G Ethernet and similar high-speed protocols while following MSA guidelines to ensure physical and electrical compatibility with equipment that accepts SFP+ optical transceivers.

Advantages

The module provides reliable short-reach 10G connectivity in a lightweight aluminium housing that helps dissipate heat. Compliance with SFP+ form factor standards ensures broad compatibility with network hardware that supports 10G SFP+ optics. The compact design and low weight simplify installation and reduce port strain in dense rack environments.

Suitable for

• Short-range 10G Ethernet links up to 30 m
• Interconnects between switches and servers within a rack or across adjacent racks
• Storage area network (SAN) links and high-speed uplinks
• Data center patch-panel connections and network aggregation

Key specifications

• Interface type: SFP+
• Maximum link distance: up to 30 meters (multimode fiber)
• Supported data rate: 10 Gbit/s
• Housing material: aluminium
• Weight: approx. 0.02 kg
• Connector type: SFP+ fiber optic receptacle (LC or platform-dependent)

How to use

Install the SFP-10G-C-BO into an available SFP+ port on a compatible switch, router or server while the host device is powered according to the equipment vendor's instructions. Connect the appropriate multimode fiber patch cord to the transceiver's optical interface and to the remote transceiver or patch panel. Verify link status on the host device and monitor diagnostics if supported. Follow the host system's guidance for hot-plugging and firmware or software settings that may be required for third-party transceivers.

Recommendations

Use certified multimode fiber patch cords and check that the network hardware supports SFP+ optical modules and any required diagnostic (DDM/DOM) features. Ensure connectors are clean before insertion to maintain optical performance. For critical links, test compatibility and link performance in your environment prior to large-scale deployment.