Módulo transceptor SFP BlueOptics SFP-10G-LR-PC-BO fibra óptica SFP+ LC

The BlueOptics SFP-10G-LR-PC-BO is a fiber optic SFP+ transceiver module designed for long-range 10GBASE-LR single-mode connections. Built in an aluminium housing with an LC duplex connector and a lightweight design of approximately 20 g, this SFP+ module supports 10 Gbit/s optical links over single-mode fiber and is intended for integration into switches, routers, storage systems and other networking hardware that accept MSA‑compliant SFP+ transceivers.

Advantages

The module follows MSA standards and is compatible with devices that support 10GBASE-LR SFP+ transceivers, providing a standard LC interface and single-mode 1310 nm transmitter/receiver operation for long-distance links. Its aluminium enclosure offers mechanical durability while the compact SFP+ form factor enables hot-pluggable installation. Designed for common high-speed applications, the transceiver supports Ethernet and other 10 Gbit/s optical protocols and includes provisions for digital diagnostics monitoring when supported by host hardware.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP-10G-LR-PC-BO transceiver into a compatible SFP+ port on the host device until it clicks into place, then connect LC duplex single-mode fiber patch cords to the TX and RX ports following the module and device polarity. Ensure the host device firmware or driver supports MSA‑compliant 10GBASE-LR SFP+ modules and enable digital diagnostic monitoring in the host if real-time parameter monitoring is required. Perform link testing and verify optical power levels and link status after installation.

Recommendations

Use single-mode fiber optic cabling and LC duplex patch cords that match transceiver polarity and link budget requirements. Verify host compatibility and, where available, enable digital diagnostics monitoring for remote monitoring of voltage, temperature, transmit/receive power and laser bias current. Handle the transceiver by the housing, avoid touching optical ferrules, and store unused modules with dust caps to protect connectors.