Módulo transceptor SFP BlueOptics SFP-10G-T-AL-BO cobre 10000 Mbit/s

The BlueOptics SFP-10G-T-AL-BO Copper 10000 Mbit/s is an SFP+ copper transceiver module designed to deliver up to 10 Gbit/s data transfer over standard copper cabling. Compatible with a range of networking equipment that supports SFP+ interfaces, this compact module weighs approximately 20 g and is finished in a nickel-coloured housing. It carries certifications including RoHS, CE, FCC and ISO9001, ensuring conformity with regulatory and quality standards for deployment in enterprise and data center environments.

Advantages

This SFP+ copper module provides a straightforward, cost-effective way to add 10 Gbit/s connectivity to compatible switches, routers and network appliances. Its compact SFP+ form factor simplifies hot-swap installation and reduces the need for additional adapters. The nickel-coloured metal housing offers mechanical robustness and electromagnetic shielding while the low weight contributes to easy handling and minimal strain on equipment slots. Compliance with common regulatory standards supports broad interoperability and reliable operation.

Suitable for

Key specifications

How to use

Ensure the target device supports SFP+ copper transceiver modules and that firmware is compatible with third‑party modules if required. With the device powered down or following the vendor's hot-swap procedure, insert the BlueOptics SFP-10G-T-AL-BO module into an available SFP+ slot until it clicks into place. Connect the appropriate copper cable to the module and to the remote port. After installation, verify link status and negotiated speed through the network device's management interface or indicator LEDs.

Recommendations

Use high-quality copper cables rated for the required 10 Gbit/s performance and keep cable runs within recommended length limits for SFP+ copper connections. Verify compatibility with the switch or router vendor and update device firmware if needed to ensure stable operation. Handle the module by its edges and store it in antistatic packaging when not installed to prevent electrostatic damage.