Módulo transceptor SFP BlueOptics SFP-1GE-FE-E-T cobre 1000 Mbit/s

The BlueOptics SFP-1GE-FE-E-T Copper 1000 Mbit/s is an SFP transceiver module designed for copper-based Ethernet connections with a maximum data transfer rate of 1000 Mbit/s. Its compact SFP form factor and silver housing enable straightforward installation into compatible SFP slots on switches, routers and media converters. The module weighs 20 g, making it suitable for deployments where space and weight are considerations, while offering a standardized interface for reliable network links.

Advantages

This SFP transceiver supports gigabit copper connectivity in a small form factor, providing a plug-and-play option for upgrading or extending network ports without replacing existing equipment. The standardized SFP interface ensures broad compatibility with devices that accept copper SFP modules. Its 1000 Mbit/s throughput supports typical LAN and access-layer traffic patterns and the lightweight, silver-metal housing offers basic mechanical protection and thermal conductance.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures recommended by your network equipment vendor and insert the BlueOptics SFP-1GE-FE-E-T into an available SFP slot until it seats firmly. Connect a suitable RJ45 copper cable to the module and to the corresponding network device. Verify link and activity LEDs on both devices and check device configuration for port speed and duplex settings if manual configuration is required. Use standard network management tools to monitor link status and throughput after installation.

Recommendations

Use shielded or unshielded twisted-pair copper cables that meet the required category for gigabit operation (Cat5e or higher). Ensure firmware and compatibility lists of the host device are checked when deploying third-party SFP modules to avoid interface restrictions. Handle the module by its housing and avoid touching connector contacts; store with dust caps when not in use.