Módulo transceptor SFP BlueOptics SFP-GE-S-2-BO 1000 Mbit/s 1310 nm

The BlueOptics SFP-GE-S-2-BO is an SFP fiber optic transceiver module designed for 1000 Mbit/s gigabit connections over single-mode or compatible fiber at a wavelength of 1310 nm. Housed in a compact silver SFP form factor, the module provides a standardized physical interface for installation in switches, routers and media converters that accept SFP modules. The unit is RoHS-compliant and intended to support reliable data transmission in enterprise and service provider networks.

Advantages

The module offers a compact SFP interface for easy hot-swapping and interoperability with equipment that supports SFP form factor optics. Operating at 1310 nm and supporting a 1000 Mbit/s transfer rate, it is suitable for long-reach multimode or single-mode links where that wavelength and speed match network design. Its silver metal housing provides mechanical protection and thermal stability while maintaining a small footprint in network racks and devices.

Suitable for

• Upgrading network ports on switches and routers to gigabit fiber connections
• Connecting switches, media converters and servers across fiber links
• Deployment in enterprise LANs and metropolitan area network segments
• Replacing faulty or outdated SFP modules with a compatible 1310 nm transceiver

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1000 Mbit/s (1 Gbit/s)
• Optical wavelength: 1310 nm
• Form factor: SFP module, hot-pluggable
• Housing: metal, silver color
• Standards compliance: RoHS

How to use

Insert the transceiver into an SFP slot on a compatible switch, router or media converter until it clicks into place. Connect the appropriate fiber patch cable to the optical port, ensuring correct fiber type and connector matching (for example LC/SC depending on your cable). Verify link status on the host device and configure network settings as required for gigabit operation. To remove, release any retention mechanism and pull the module straight out while the device is powered down or following the equipment vendor's hot-swap guidance.

Recommendations

Ensure that the optical budget, connector type and fiber type in your installation are compatible with a 1310 nm transceiver and 1000 Mbit/s operation. Handle the module by its housing, avoid touching the optical interface, and keep dust caps on when not in use to maintain signal integrity. Follow vendor guidance for compatibility with specific network devices.