Módulo transceptor SFP BlueOptics SFP28-25G-ERL-30-MT-BO 25000 Mbit/s

The BlueOptics SFP28-25G-ERL-30-MT-BO is a single‑mode fiber optic SFP28 transceiver module engineered for 25 Gbit/s class links. Designed for data center and enterprise network deployments, this module provides a compact SFP28 form factor and supports high-speed serial connectivity over fiber, enabling reliable long-reach connections where low latency and stable throughput are required.

Advantages

This SFP28 module delivers a 25 Gbit/s maximum data transfer rate in a standardized SFP28 interface, allowing interoperability with compatible switches and routers. Its compact design conserves port density in rack environments, while fiber connectivity reduces electromagnetic interference and supports longer transmission distances compared with copper. The module is a practical choice when consistent high-throughput links and predictable signal quality are needed.

Suitable for

• Data center uplinks and spine-to-leaf connections
• Enterprise core and aggregation switches
• High-performance server NIC interconnects
• Longer-reach fiber runs within campus or metropolitan networks

Key specifications

• Interface type: SFP28
• Maximum data transfer rate: 25000 Mbit/s
• Single‑mode fiber support for long‑reach connections
• Hot-pluggable small form factor compatible with SFP28 cages

How to use

Insert the transceiver into a compatible SFP28 port on a switch, router, or network interface card until it clicks into place. Connect an appropriate single‑mode fiber patch cable to the transceiver's optical port using the correct connector type for your equipment. Verify link status in the device management interface and configure the port speed and duplex settings according to network design. When removing the module, power down the port if required by your equipment, then press the release latch and gently withdraw the transceiver.

Recommendations

Ensure compatibility by checking the host device's SFP/SFP28 optics support and adopting single‑mode fiber and connectors that match your installation. Maintain clean fiber connectors and follow standard ESD precautions when handling the module. Monitor link status after installation to confirm stable operation at 25 Gbit/s.