Módulo transceptor SFP+ BlueOptics UF-SM-10G-S-1270-40 10000 Mbit/s

The BlueOptics UF-SM-10G-S-1270-40 is an SFP+ fiber optic transceiver module engineered for 10 Gbit/s network links. Designed to fit standard SFP+ ports, it provides single-mode fiber connectivity using a 1270 nm wavelength and supports reliable high-speed data transmission up to 10000 Mbit/s. The compact module is intended for integration into switches, routers and optical line equipment where a small form-factor, low-latency connection is required.

Advantages

This SFP+ transceiver offers stable 10 Gbit/s throughput in a standardized SFP+ package, enabling straightforward hot-pluggable installation and compatibility with a wide range of networking hardware. Its single-mode operation at 1270 nm is optimized for long-reach or wavelength multiplexing applications. The module’s compact size and defined interface reduce the need for additional adapters, simplifying rack and cabinet installations.

Suitable for

• 10 Gbit/s backbone links between switches and routers
• Data center uplinks and server connections
• Long-reach single-mode fiber links and wavelength-division multiplexing setups
• Network equipment requiring SFP+ form-factor transceivers

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Operating wavelength: 1270 nm
• Fiber type: Single-mode
• Form factor: SFP+ small form-factor pluggable

How to use

Install the BlueOptics UF-SM-10G-S-1270-40 by inserting it into an available SFP+ port on compatible network equipment until it clicks into place. Connect single-mode fiber patch cords with appropriate connectors to the module’s optical port, ensuring correct polarity. Configure the host device’s interface parameters as required by your network (for example enabling the 10 Gbit/s link and any necessary VLAN or trunk settings). The module supports hot-plugging but handle it according to equipment guidelines and observe ESD precautions during installation.

Recommendations

Use single-mode fiber cabling rated for the expected reach and keep connectors clean to maintain signal integrity. Verify compatibility with the host device firmware and transceiver acceptance lists when possible. Avoid exposing the module to excessive dust, moisture, or mechanical stress during installation and operation.