Tubo rígido 14 mm DE, 500 mm — BitsPower Bitspower None Chamfer latón, negro carbón

BitsPower hard tubing, 14 mm outer diameter and 500 mm length, is a rigid brass tube finished in carbon black designed for custom PC liquid cooling loops. The brass construction offers mechanical strength and corrosion resistance suitable for long-term installations. The tube's precise outer diameter ensures a tight, reliable fit with compression-style fittings and other components engineered for 14 mm tubing, making it suitable for visible runs and compact loop geometries where straight, sturdy segments are required.

Advantages

The brass hard tubing provides improved rigidity compared with soft tubing, reducing sag and maintaining defined shapes in the cooling loop. Its corrosion-resistant brass alloy and factory finish simplify installation and visual consistency across exposed sections. The accurate 14 mm outer diameter minimizes play with matching fittings, supporting leak-free connections when used with compatible compression fittings. The 500 mm length allows for single-piece straight runs or can be cut to custom lengths for bends and fittings.

Suitable for

• Custom PC water cooling loops with compression or push-fit fittings sized for 14 mm outer diameter tubing
• Visible tubing runs where a finished carbon black appearance is desired
• Compact or mid-size cases requiring precise rigid sections for short straight connections
• Builds that prioritize mechanical stability and longevity of coolant paths

Key specifications

• Material: Brass (rigid metal tubing)
• Outer diameter: 14 mm
• Length: 500 mm
• Finish: Carbon black external coating
• Intended use: Rigid tubing for liquid cooling loops in PCs

How to use

Measure and mark the required length for each run, then cut the brass tubing with an appropriate tube cutter or saw suitable for metal. Deburr and polish the cut ends to ensure smooth sealing surfaces. Install the tubing into compatible compression fittings by inserting the tube until it seats fully and tightening the fitting according to the fitting manufacturer's torque or hand-tightening guidance. Test the system with a leak test before full operation, using non-conductive coolant if preferred for initial testing.

Recommendations

When preparing and installing brass hard tubing, use proper personal protective equipment and tools for cutting and deburring. Match fittings and seals explicitly to 14 mm outer diameter tubing and follow the fitting manufacturer's instructions for tightening. Perform a controlled leak test and inspect joints visually and under pressure before powering the system.