Cable de red EFB Elektronik K8104WS.20 RMS45 RJ-45 Cat6 20 m blanco

The EFB Elektronik K8104WS.20 networking cable is a 20 m Cat6 U/UTP cable with RMS45 to RJ-45 connectors and gold-plated contacts. Designed to support data transfer rates up to 5000 Mbit/s, this white cable is intended for reliable wired network connections in home, office, and data center environments where Cat6 performance and a longer reach are required.

Advantages

This Cat6 U/UTP cable provides high-speed data transmission with gold-plated contacts on RMS45 and RJ-45 connectors to improve signal contact and reduce corrosion. The 20 m length allows flexible placement of network devices without additional intermediate hardware. Constructed for compatibility with standard Cat6 installations, the cable supports stable wired networking and is suitable for environments that need consistent throughput over a longer cable run.

Suitable for

• Connecting routers, switches and networked devices across medium to large rooms
• Structured cabling runs in small offices or home networks
• Temporary or permanent connections in server rooms and wiring closets
• Applications requiring Cat6 performance with RMS45 or RJ-45 terminations

Key specifications

• Cable length: 20 m
• Category: Cat6
• Shielding: U/UTP (unshielded twisted pair with overall unscreened construction)
• Connectors: RMS45 to RJ-45
• Contacts: Gold-plated
• Color: White
• Maximum data transfer rate: up to 5000 Mbit/s

How to use

Identify the network ports on your devices that accept RMS45 or RJ-45 connectors and route the 20 m cable between them, avoiding sharp bends and heavy crushing points. Insert the RMS45 and RJ-45 connectors fully into the corresponding ports until they click to ensure secure contact. For best results, maintain standard installation practices for Cat6 cables: keep power and data cables separated where possible and avoid running the cable alongside sources of strong electromagnetic interference.

Recommendations

For optimal performance, test the cable after installation with network testing tools appropriate for Cat6 to verify connectivity and throughput. Use the 20 m length for direct device connections or structured cabling where a single uninterrupted Cat6 run is required; replace the cable if connectors show physical damage or if performance measurements fall below expected levels.