Módulo transceptor de red Lanview MO-XBR-000198 16000 Mbit/s SFP+ 1310 nm

The Lanview MO-XBR-000198 is a network transceiver module that supports data transmission up to 16000 Mbit/s. Equipped with an SFP+ interface and operating at a wavelength of 1310 nm, this module uses an LC fiber-optic connector to provide stable optical links for compatible switches, routers and transceivers. It is intended for use in fibre-optic network segments requiring single-mode operation at the specified wavelength and data rate.

Advantages

This SFP+ transceiver delivers up to 16000 Mbit/s throughput and uses a 1310 nm wavelength suitable for medium- to long-distance single-mode fibre connections. The LC connector ensures wide compatibility with standard fibre cables and the compact SFP+ form factor allows installation in port-dense network equipment. The module is manufactured to match typical industry interface and optical specifications for straightforward integration.

Suitable for

• Upgrading or expanding SFP+ ports on switches and routers
• Single-mode fibre links using 1310 nm wavelength
• Data centre uplinks and aggregation links
• Telecom and enterprise backbone connections

Key specifications

• Manufacturer: Lanview
• Model / MPN: MO-XBR-000198
• Interface: SFP+
• Data rate: 16000 Mbit/s
• Wavelength: 1310 nm
• Connector type: LC (fiber optic)
• EAN: 5711783907954

How to use

Insert the Lanview MO-XBR-000198 into a compatible SFP+ slot on your network device while the device is powered down or following the manufacturer's hot-swap guidelines. Connect an appropriate single-mode LC fiber cable to the module's LC port. Configure the host device interfaces and link settings as required by your network topology and monitoring systems. Verify link status and diagnostic information via the device management interface.

Recommendations

Use this transceiver with single-mode fibre at the specified 1310 nm wavelength and within the supported distance range for your equipment. Ensure firmware and device compatibility before deployment and handle the optical connector with dust caps removed only at the time of connection to avoid contamination.