Módulo transceptor SFP BlueOptics 1286720000-BO 1250 Mbit/s

The BlueOptics 1286720000-BO SFP transceiver module is engineered for fiber optic network connections requiring a 1250 Mbit/s data rate. Offered in a silver metal housing and weighing approximately 20 g, this small form-factor pluggable (SFP) module supports single‑mode links up to 10,000 m using an LC (UPC) connector. The module implements a 1.25 Gigabit Ethernet interface and is specified with an MTBF of 1,000,000 hours to support sustained operation in network applications.

Advantages

This SFP transceiver provides a compact, hot‑swappable solution for adding fiber connectivity to switches, routers and media converters. With support for up to 10 km single‑mode distances and an LC (UPC) fiber connector, it enables long‑reach links while occupying minimal rack space. The 1,000,000‑hour MTBF indicates design focus on reliability, and the standardized SFP form factor ensures wide compatibility with equipment that accepts 1.25 Gbps SFP modules.

Suitable for

• Extending optical links between switches and routers over single‑mode fiber up to 10 km
• Replacing or upgrading existing SFP ports to 1.25 Gbit/s fiber connections
• Use in media converters and network appliances requiring LC (UPC) fiber interfaces
• Laboratory setups and test environments that require hot‑swappable SFP modules

Key specifications

• Maximum data transfer rate: 1250 Mbit/s (1.25 Gbit/s)
• Maximum transfer distance: up to 10,000 m (single‑mode fiber)
• Ethernet interface type: 1.25 Gigabit Ethernet (SFP)
• Fiber optic connector: LC (UPC)
• Product colour: Silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Install the BlueOptics SFP transceiver into a compatible SFP port on your switch, router or media converter while the host device is powered on or off according to the host vendor's guidelines. Connect a single‑mode LC (UPC) fiber patch cable to the module's LC port, ensuring correct alignment of transmit and receive channels. Configure the host device's port settings to operate at 1.25 Gbit/s if manual configuration is required. Monitor link status through the host device management interface to confirm successful negotiation and link integrity.

Recommendations

Use single‑mode LC (UPC) fiber cable rated for the required distance and maintain clean connector endfaces to preserve optical performance. Verify compatibility with the host equipment's SFP specifications and follow ESD precautions when handling the module. For long‑term reliability, avoid operating the module outside the environmental ranges specified by the host device.