Módulo transceptor SFP28 BlueOptics SFP28-25G-ERL-30-AT-BO 25000 Mbit/s

The BlueOptics SFP28-25G-ERL-30-AT-BO is a single-port SFP28 fiber optic transceiver module engineered for 25 Gbit/s network links. Designed for high-performance environments, the module supports a maximum data transfer rate of 25,000 Mbit/s and a link reach up to 30,000 metres over single-mode fibre using an LC connector. The SFP28 form factor ensures compatibility with modern switches, routers and network interface cards that accept SFP28 modules, enabling reliable long-reach connectivity for data centres and carrier networks.

Advantages

This transceiver offers high-speed 25 Gbit/s transmission and extended reach to 30 km, combining low-power SFP28 form factor benefits with long-distance single-mode operation. The LC connector provides a compact duplex interface for fibre links, while the module’s compatibility with standard SFP28 slots simplifies upgrades in existing network infrastructure. Its design focuses on dependable signal integrity and predictable performance across point-to-point optical links.

Suitable for

• Data centre uplinks and spine-leaf fabric connections
• Long-distance single-mode links between buildings or campuses
• Carrier and metro Ethernet aggregation
• High-performance server-to-switch interconnects

Key specifications

• Interface type: SFP28 (25 Gbit/s)
• Maximum data transfer rate: 25000 Mbit/s
• Maximum transfer distance: 30000 m (single-mode fibre)
• Fibre connector: LC duplex
• Transmission type: single-mode optical link

How to use

Install the module into a compatible SFP28 port on the switch, router or host adapter until it clicks into place; verify that equipment is powered down or hot-swap capable according to the platform’s guidelines. Connect duplex LC single-mode fibre patch cables to the module’s LC ports, respecting transmit/receive orientation. After physical installation, check link status and data rate on the networking device and configure interface settings (speed, duplex, media type) as required by your network management system.

Recommendations

Use high-quality single-mode LC patch cables and maintain proper fibre handling to avoid contamination; clean connector endfaces before mating. Verify transceiver compatibility with the host device vendor and keep firmware or driver software up to date for optimal link stability. For maximum reach and performance, follow specified optical power budgets and avoid bending or stressing fibre runs.